Recent content by Pappy

  1. Pappy

    Fitting 16” Wheels On 4G Tacoma - Shaving Caliper, Spacers, Trimming

    The other issue to check is the brake hose in the rear. Trucks with 17" wheels had an issue with rubbing after the wheel packed with mud. That lead to a recall in early 2025.
  2. Pappy

    C4 Lo-Pro front bumper and C4 rear bumper, feedback?

    I get 16-17mpg, but I'm heavier. Same tire. 6MT.
  3. Pappy

    C4 Lo-Pro front bumper and C4 rear bumper, feedback?

    Fog lights. They are wired through one of the dash aux switches. It was stupid easy, at least for me. MPG. This was installed as part of a larger build. Heavy rear bumper, a canopy camper, and a little lift. So ya, my MPG tanked, but I doubt the front bumper had anything to do with it.
  4. Pappy

    C4 Lo-Pro front bumper and C4 rear bumper, feedback?

    I have the C4 Lo-Pro on mine. The only issue I had was the winch. I have a Warn XD9 with the 9.5XP 6hp motor. It didn't fit the cradle. Installing the original XD9 motor did fit. I used a relocation cable from Warn ($$$) to move the winch controller plug to the front of the bumper. Last, I...
  5. Pappy

    Rear Spring Upgrade for a Light Camper Setup

    There is information on the Dobinsons website. Here is a copy and paste. Rear Springs C59-869V (30mm - 1.25") Stock Load / (Stock Height) 50-100lbs C59-817V (55mm - 2.25") 50-100lb Load / (30mm - 1.25") 175-330lb Load C59-819V (55mm - 2.25") 175- 330lb Load / (30mm - 1.25") 440-660lb Load...
  6. Pappy

    Rear Spring Upgrade for a Light Camper Setup

    I ran the 819 springs on mine with my canopy camper. I thought they were wimpy. I then installed the 821, and they still were not enough, so I installed the 1/2" spacer. It's still not where I want it, but will work for now. I will probably at some point install the 823 springs.
  7. Pappy

    Bed Topper Option? With Side Tool Storage Ideally!

    Dirtbox Overland. You can get molle box side panels to hold your junk. https://dirtboxoverland.com/pages/truck-bed-topper-info The molle box inside mine.
  8. Pappy

    Spending $8,500 on Fox Live Valve — heres whats actually in the kit

    Geez, now I need to figure out what I did with that CAN cable.
  9. Pappy

    Show Me Your Tire Inflation/Deflation (Portable Air) Setups!

    No need for a picture. I just carry a Viair 400P-A. I do have a SAE port on the front bumper to plug it in. That way I don't need to lift the hood to attach alligator clips to the battery. It lives in my camper-canopy behind one of the gull-wing doors so it's super easy to access.
  10. Pappy

    WTB/ISO: Sliders & Skids

    I have a front Rough County skid I'm not using. Never installed. I have just the front skid, not the rear. $50 plus the ride from NM. I also see Rough Country has them in stock.
  11. Pappy

    Dyno Tuned Today

    Email him. I suspect 2024=2025=2026.
  12. Pappy

    Dyno Tuned Today

    The last I saw tunes for the hybrids was not available, but they were working on it. Some the the black magic Cam did was tweek the boost. Both the amount and the timing.
  13. Pappy

    Dyno Tuned Today

    After Cam did a driveway tune on Saturday we went for a putt. The first thing I noticed was throttle response from a standing stop. With the 285/70's and the camper the truck was a slug to get moving. Not any more. The difference between before and after was huge. The truck has a lot more pep...
  14. Pappy

    Dyno Tuned Today

    Cam starts with the Cobb AccessPort which plugs into the service port under the dash. You would need to visit his website for details. As I understand it, Cobb has a tune in the AccessPort for the Gen4 Tacoma that can be bought. But, Cam has the ability to tune the engine further on the dyno...
Back
Top