Recent content by vidicious

I didn't get that option, but if you can point me to any schematics, 3d models, or anything pertinent, I can make something :unsure:

Thanks! Just getting started, but I was happy with this one!!

I've tried 5 so far. The trim ring shown is bronze PLA and the phone charger matte black PLA. I usually use PLA for prototyping, and lean to other stuff for longevity with temperature swings. That said I made a phone holder out of PLA for my neighbor that lasted thru scorching summer temps with...

Getting to know the vehicle today ... Found two unused connectors tucked into the console below the automatic shift lever. One blue, one white, four wires each. Also found an unexpected bunch of wiring beyond the 12V power supply to the back seats ... long green plastic piece right under the...

One day old TRD Sport with 21 miles ... snowy day in Colorado. Designed and printed simple trim rings to snap into place on the climate and drive mode knobs. I don't like the fake screw heads on the OEM knobs. Also designed an iphone charger pad. I like it better than the factory wireless...