Economical Exhaust Beauty Tip Alternative

SXTHElement · 2025-08-01T14:04:26+00:00

Hey everyone, We just finished dyno testing our new front mount intercooler for the 2024+ Tacoma, and wanted to share some real numbers and context with you all. This test was done on a stock truck with only our intercooler installed — no intake, no tune. The goal was to isolate what the intercooler alone can do. We used 4th gear on the 10-speed auto, which meant we had to feather the throttle below 4K RPM to avoid kickdown, so the low-end numbers are a bit skewed. But above 4K, the results were extremely consistent and repeatable. Here’s what we saw comparing OE vs SXTH intercooler: Peak power jumped from 248.6 hp to 264.1 hp (+15.5 hp) Peak torque increased from 288.6 lb-ft to 303 lb-ft (+14.4 lb-ft) Midrange output was noticeably stronger across every run Even in worst-case comparisons, our core outperformed factory We’re seeing lower intake temps across the board thanks to: A bar and plate core with 45% more volume Lower pressure drop (1.5 psi vs 2.4 psi stock) Up to 50°F lower temps at the turbo outlet and 12°F lower post-intercooler It’s a direct bolt-on, retains all OEM sensors and components (including grille shutters), and doesn’t require a tune. It’s also compatible with the 2025+ 4Runner and 2024+ Land Cruiser LC250. Product page for anyone interested: https://sxthelement.com/products/2024-toyota-tacoma-4runner-land-cruiser-front-mount-intercooler – Nathan @ SXTH Element

Phadreus

New member

Mar 23, 2025

#1

I see allot of expensive options to cover the end of the exhaust outlet, some of them upwards of $200. If you don't mind not having a cool log on it, I found a much less expensive option at CarID:

Stainless Round Tip

I cut about 8" off my stock pipe and slipped the tip over, clamped it down with provided toothed cleats and viola: