- Joined
- Mar 26, 2024
- Messages
- 586
- Reaction score
- 319
Check it out! I got these flares a while back and finally got around to getting some unboxing shots and installing them.
NYTOP makes a bunch of OE-like accessories for several Toyota trucks, both new and old gens. Check them out if you're looking for some unique stuff. They have bumpers, recovery points, rock sliders, quite a few different options.
This is their Tacoma Fender Flare Kit. It comes in either matte carbon or gloss carbon. I like how the gloss flares look on the Pro models, so I went with gloss. It adds 1" of width per side for all trims but the SR and SR5, where they add 1.5". I think, given the already wide truck, higher offset wheels, that these flares could potentially take the place of fiberglass for up to a 2" LT kit. Much easier and still gets a similar look.
The bottom of the front flares kinda mimics the Trailhunter and Pro variants with a beveled edge with fins. It's a really nice touch. This is real carbon fiber... so there's no place for mounting clips inside. You use two layers of thick, high end 3M tape around the entire outer perimeter, and the inner fender bolts to attach them.
Check them out here - https://nytop.com/toyota-tacoma-accessories-store/p/2024-current-toyota-tacoma-fender-flare-kit
I'll post some installed photos soon. Stay tuned! But take a look at some close-ups below. They were just wiped down and the weave was really popping in the sun.
NYTOP makes a bunch of OE-like accessories for several Toyota trucks, both new and old gens. Check them out if you're looking for some unique stuff. They have bumpers, recovery points, rock sliders, quite a few different options.
This is their Tacoma Fender Flare Kit. It comes in either matte carbon or gloss carbon. I like how the gloss flares look on the Pro models, so I went with gloss. It adds 1" of width per side for all trims but the SR and SR5, where they add 1.5". I think, given the already wide truck, higher offset wheels, that these flares could potentially take the place of fiberglass for up to a 2" LT kit. Much easier and still gets a similar look.
The bottom of the front flares kinda mimics the Trailhunter and Pro variants with a beveled edge with fins. It's a really nice touch. This is real carbon fiber... so there's no place for mounting clips inside. You use two layers of thick, high end 3M tape around the entire outer perimeter, and the inner fender bolts to attach them.
Check them out here - https://nytop.com/toyota-tacoma-accessories-store/p/2024-current-toyota-tacoma-fender-flare-kit
I'll post some installed photos soon. Stay tuned! But take a look at some close-ups below. They were just wiped down and the weave was really popping in the sun.
