Perry Parts Rear Bump Stops Installed

Dyno-Proven Gains from Our SXTH Intercooler

SXTHElement · 2025-08-01T14:04:26+00:00

Hey everyone, We just finished dyno testing our new front mount intercooler for the 2024+ Tacoma, and wanted to share some real numbers and context with you all. This test was done on a stock truck with only our intercooler installed — no intake, no tune. The goal was to isolate what the intercooler alone can do. We used 4th gear on the 10-speed auto, which meant we had to feather the throttle below 4K RPM to avoid kickdown, so the low-end numbers are a bit skewed. But above 4K, the results were extremely consistent and repeatable. Here’s what we saw comparing OE vs SXTH intercooler: Peak power jumped from 248.6 hp to 264.1 hp (+15.5 hp) Peak torque increased from 288.6 lb-ft to 303 lb-ft (+14.4 lb-ft) Midrange output was noticeably stronger across every run Even in worst-case comparisons, our core outperformed factory We’re seeing lower intake temps across the board thanks to: A bar and plate core with 45% more volume Lower pressure drop (1.5 psi vs 2.4 psi stock) Up to 50°F lower temps at the turbo outlet and 12°F lower post-intercooler It’s a direct bolt-on, retains all OEM sensors and components (including grille shutters), and doesn’t require a tune. It’s also compatible with the 2025+ 4Runner and 2024+ Land Cruiser LC250. Product page for anyone interested: https://sxthelement.com/products/2024-toyota-tacoma-4runner-land-cruiser-front-mount-intercooler – Nathan @ SXTH Element

rustytaco

Administrator

Staff member

Feb 15, 2025

Got my lift kit, wheels and tires installed this past Monday. Added these Perry Parts bumps to complement the rear end. These should work much better than the stock ones. The install is super simple. You just take off the old bump/bracket, and bolt these new ones in. I'll post an update in the future after we do more testing.

Find them online - direct link.

Perry Parts Rear Bump Stops Installed

rustytaco

Administrator

Recent

Dyno-Proven Gains from Our SXTH Intercooler

Should I Sell My Fully Built 3rd Gen for a 4th Gen Tacoma?

Rough Country Liners for Tacoma: Solution or Airflow Problem?

Custom Tacoma Audio Build: Kenwood Components and MTX Sub Install

Exploring Sidio Crates for my Tacoma Truck: A Budget-Friendly Alternative to Milwaukee Packout

Quick Guide to Using Your Tacoma's Shift Lock Override

Tacoma Sxth Element Intake: 30-Min Install with Killer Turbo Whoosh

Tacoma RC 87 +00 Offset: How’s the Fitment on Your Truck?

Sharing a Budget-Friendly Tacoma Interior Mod: Vibrant Vinyl Logo Decal

How I Fixed My Tacoma's Trailer Issue with a Simple 7-Pin Plug Tweak

Mace MFG Volume Knob

Fitting 0 Offset Wheels On A 4th Gen Tacoma

Similar threads